Wire Harness Inspection Products
Tensile Strength Measurement at Constant Speed
Requesting Main Industry : Manufacture of automotive harnesses
A crimp terminal rupture tester that can be pulled at a constant speed is needed
Problems we had
In the manual tensile testing machine, the measured value may vary depending on the force of the human hand. It should be pulled at a predetermined speed and measure an accurate rupture value.
Solving Problems
The crimp terminal auto-pull tester can measure breaking forces up to max. 1000N at a specified rate.
Introduced equipment
Other examples of introduction
Industry : Manufacture of automotive harnesses
A non-harmful liquid is needed when performing surface treatment when preparing cross-sectional samples
Since deleterious substances (...
Industry : Manufacture of automotive harnesses
The Cross-Sectional Sample Preparation Efficiency of Crimping Terminals should and the Crimping Quality should be improved
Cross-sectional evaluation of ...
Industry : Manufacture of automotive harnesses
Measuring the dimensions of the wire peeling length before crimping is needed
There is a special terminal wh...
Industry : Production of consumer harnesses
Voluntary inspections by facility operators should be eliminated to save manpower
The self-inspection of workers...
Industry : Manufacture of automotive harnesses
I want to detect a defective crimp that could not be found by visual inspection
Visual inspection results in h...
